Monitoring poles are very common in life, so how to install monitoring poles? Let's introduce the installation method for you.

Monitoring pole installation 1: beside the pole, beside the control box, at the bend of the cable, when the straight line length of the cable pipe exceeds 50 meters or when the cable pipe at both ends is not at the same plane more than 100mm apart, the hand hole must be set up.

Monitoring pole installation ii: The internal dimension of the hand-hole well shall be 500(l)×500(W)×600(d)MM, and gravel layer shall be used for water seepage; The walls of hand hole must be plastered with cement mortar.

Monitoring pole installation 3: The control box is equipped by the equipment manufacturer according to the required capacity, the shell is made of high-quality cold-rolled steel plate with wall thickness no less than 1.2mm, and the outer surface is sprayed with plastic powder, and it is waterproof, anti-theft and heat dissipation.

Monitoring pole installation iv: structural steel shall not affect the material and mechanical properties of cracks, lamination, heavy skin, slag inclusion and other defects pitting or scratch depth shall not be greater than 1/2 of the steel thickness tolerance, and shall not be greater than 0.5mm.

Monitoring stud to install 5: design basis, design wind load: 23 m/s2, fatigue life: 30 years, according to the latest standards of the state version "carbon structural steel", "electrical equipment installation project cable line code for construction and acceptance, the steel structure engineering construction and acceptance standard", "acceptance specification for construction of reinforced concrete engineering and other related regulations, carry out the construction.

After understanding the installation of monitoring pole, I believe that in the future, we will have a general plan in mind, which can save a lot of time.